Normal operating condition

Description FUEL CUT CONTROL (AT NO LOAD AND HIGH ENGINE SPEED) If the engine speed is above 1,800 rpm under no load (for example, the selector lever position is neutral and engine speed is over ...

Idle speed

Description This describes how to check the idle speed. For the actual procedure, follow the instructions in “BASIC INSPECTION”. Special Repair Requirement 1.CHECK IDLE SPEED With CONSULT-I ...

Other materials:

B2205 vehicle speed
Description Vehicle speed signal is transmitted from ABS actuator and electric unit (control unit) via CAN communication to combination meter. DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.PERFORM SELF-DIAGNOSIS OF ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) Perform “Self Diagno ...

Wiring diagram
IPDM E/R Wiring Diagram For connector terminal arrangements, harness layouts, and alphabets in a (option abbreviation; if not described in wiring diagram), refer to GI-12, "Connector Information/Explanation of Option Abbreviation". ...

B26F2 ignition relay
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON under the following conditions, and wait for 2 seconds or more. CVT models - Selector lever is in the P or N position - Do not depress brake pedal M/T models - Do n ...