Nissan Juke Service and Repair Manual : B2191 difference of key

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON.

2. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III.

Is DTC detected? YES >> Refer to SEC-203, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.PERFORM INITIALIZATION

Perform initialization of BCM and reregistration of all ignition keys using CONSULT-III.

For initialization and registration procedures, refer to CONSULT-III Operation Manual NATS-IVIS/NVIS.

Can the system be initialized and can the engine be started with reregistered ignition key? YES >> INSPECTION END

NO >> GO TO 2.

2.REPLACE IGNITION KEY

1. Replace ignition key.

2. Perform initialization of BCM and reregistration of all ignition keys using CONSULT-III.

For initialization and registration procedures, refer to CONSULT-III Operation Manual NATS-IVIS/NVIS.

Can the system be initialized and can the engine be started with reregistered ignition key? YES >> INSPECTION END

NO >> GO TO 3.

3.REPLACE BCM

1. Replace BCM. Refer to BCS-161, "Removal and Installation".

2. Perform initialization of BCM and reregistration of all ignition keys using CONSULT-III.

For initialization and registration procedures, refer to CONSULT-III Operation Manual NATS-IVIS/NVIS.

>> INSPECTION END

    B2190 nats antenna AMP
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Check DTC in “Self Diagnostic Result” mode of “BCM” using CO ...

    B2192 ID discord, IMMU-ECM
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Check DTC in “Self Diagnostic Result” mode of “BCM” using CO ...

    Other materials:

    P0848 transmission fluid pressure SEN/SW B
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, the ignition switch OFF and wait for at least 10 seconds, then perform the next test. >> GO TO 2. 2.CHECK DTC DETECTION With ...

    Excessive operation frequency
    Description ABS function and EBD function operates in excessive operation frequency. Diagnosis Procedure 1.CHECK BRAKING FORCE Check brake force using a brake tester. Is the inspection result normal? YES >> GO TO 2. NO >> Check brake system. 2.CHECK FRONT AND REAR AXLE Che ...

    Repairing material
    Foam Repair During factory body assembly, foam insulators are installed in certain body panels and locations around the vehicle. Use the following procedure(s) to replace any factory-installed foam insulators. URETHANE FOAM APPLICATIONS Use commercially available Urethane foam for sealant ...