Nissan Juke Service and Repair Manual : B2192 ID discord, IMMU-ECM

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON.

2. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III.

Is DTC detected? YES >> Refer to SEC-204, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.PERFORM INITIALIZATION

Perform initialization of BCM and reregistration of all ignition keys using CONSULT-III.

For initialization and registration procedures, refer to CONSULT-III Operation Manual NATS-IVIS/NVIS.

Can the system be initialized and can the engine be started with reregistered ignition key? YES >> INSPECTION END

NO >> GO TO 2.

2.CHECK SELF DIAGNOSTIC RESULT

1. Select “Self Diagnostic Result” mode of “ENGINE” using CONSULT-III.

2. Erase DTC.

3. Perform DTC CONFIRMATION PROCEDURE for DTC B2192. Refer to SEC-204, "DTC Logic".

Is DTC detected? YES >> GO TO 3.

NO >> INSPECTION END

3.REPLACE BCM

1. Replace BCM. Refer to BCS-161, "Removal and Installation".

2. Perform initialization of BCM and reregistration of all ignition keys using CONSULT-III.

For initialization and registration procedures, refer to CONSULT-III Operation Manual NATS-IVIS/NVIS.

Can the system be initialized and can the engine be started with reregistered ignition key? YES >> INSPECTION END

NO >> GO TO 4.

4.REPLACE ECM

Replace ECM.

Refer to EC-447, "Removal and Installation" (MR16DDT), or EC-805, "Removal and Installation" (HR16DE).

>> INSPECTION END

    B2191 difference of key
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Check DTC in “Self Diagnostic Result” mode of “BCM” using CO ...

    B2193 chain of ECM-IMMU
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B2193 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS-153, "DTC Logic". • If DTC B2193 is ...

    Other materials:

    Diagnosis system (BCM)
    Common item COMMON ITEM : CONSULT-III Function (BCM - COMMON ITEM) APPLICATION ITEM CONSULT-III performs the following functions via CAN communication with BCM. SYSTEM APPLICATION BCM can perform the following functions for each system. NOTE: It can perform the diagnosis modes except the ...

    L terminal circuit (short)
    Description The “L” terminal circuit controls the charge warning lamp. The charge warning lamp illuminates when the ignition switch is set to ON or START. When the alternator is providing sufficient voltage with the engine running, the charge warning lamp will go off. If the charge warnin ...

    B2192 ID discord, IMMU-ECM
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III. Is DTC detected? YES >> Go to SEC-60, "Diagnosis Procedure". NO &g ...