Nissan Juke Service and Repair Manual : Diagnosis system (BCM)
Common item
COMMON ITEM : CONSULT-III Function (BCM - COMMON ITEM)
APPLICATION ITEM
CONSULT-III performs the following functions via CAN communication with BCM.

SYSTEM APPLICATION
BCM can perform the following functions for each system.
NOTE
:
It can perform the diagnosis modes except the following for all sub system
selection items.

• *1: This item is displayed, but is not used.
• *2: For models with automatic A/C, this mode is not used.
Theft ALM
THEFT ALM: CONSULT-III Function (BCM - THEFT)
WORK SUPPORT

ACTIVE TEST

IMMU
IMMU : CONSULT-III Function (BCM - IMMU)
WORK SUPPORT

ACTIVE TEST

System
NISSAN anti-theft system
NISSAN ANTI-THEFT SYSTEM : System Diagram
NISSAN ANTI-THEFT SYSTEM : System Description
SYSTEM DESCRIPTION
Nissan Anti-Theft System (NATS) has the following immobilizer ...
ECU diagnosis information
ECM, BCM
List of ECU Reference
...
Other materials:
B260F Engine status
Description
BCM receives the engine status signal from ECM via CAN communication.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B260F is displayed with DTC U1000, first perform the trouble diagnosis
for DTC U1000. Refer to
BCS-83, "DTC Logic".
• If DTC B260F is displayed with D ...
Component parts
Component Parts Location
MODELS WITH USB CONNECTION FUNCTION
1. Front door speaker LH
2. Rear door speaker LH
3. Rear door speaker RH
4. Antenna rod
5. Antenna base (antenna amp.)
6. Front door speaker RH
7. Microphone
8. Tweeter LH
9. Steering switch
10. USB connector and AUX jac ...
C1142 press sensor
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn
ignition switch OFF and
wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
With CON ...
