Nissan Juke Service and Repair Manual : Vehicle security alarm does not activate

Description

Alarm does not operate when alarm operating condition is satisfied.

NOTE

:
Check that vehicle is under the condition shown in “CONDITIONS OF VEHICLE (OPERATING CONDITIONS)” before starting diagnosis, and check each symptom.

CONDITION OF VEHICLE (OPERATING CONDITIONS)

“SECURITY ALARM SET”: ON

Check the setting of “SECURITY ALARM SET” in “Work Support” mode of “THEFT ALM” of “BCM” using CONSULT-III.

Diagnosis Procedure

1.CHECK DOOR SWITCH

Check door switch.

Refer to DLK-87, "Component Function Check" (With super lock) or DLK-258, "Component Function Check" (Without super lock).

Is the inspection result normal? YES >> GO TO 2.

NO >> Replace the malfunctioning door switch 2.CHECK HOOD SWITCH

Check hood switch.

Refer to SEC-155, "Component Function Check".

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace hood switch.

3.CHECK HAZARD WARNING LAMPS FUNCTION

Check hazard warning lamps function.

Refer to EXL-69, "Component Function Check".

Is the inspection result normal? YES >> GO TO 4.

NO >> Repair or replace the malfunctioning parts.

4.CHECK HORN FUNCTION

Check horn function.

Refer to SEC-157, "Component Function Check".

Is the inspection result normal? YES >> GO TO 5.

NO >> Repair or replace the malfunctioning parts.

5.CONFIRM THE OPERATION

Confirm the operation again.

Is the result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

NO >> GO TO 1.

    Vehicle security system cannot BE set
    INTELLIGENT KEY INTELLIGENT KEY : Description Armed phase is not activated when door is locked using Intelligent Key. NOTE: Check that vehicle is under the condition shown in “CONDITIONS OF VE ...

    Other materials:

    Brake system
    BRAKING PRECAUTIONS The brake system has two separate hydraulic circuits. If one circuit malfunctions, you will still have braking at two wheels. You may feel a small click and hear a sound when the brake pedal is fully depressed slowly. This is not a malfunction and indicates that the brake ...

    Service information for electrical incident
    Work Flow WORK FLOW Control Units and Electrical Parts PRECAUTIONS • Never reverse polarity of battery terminals. • Install only parts specified for a vehicle. • Before replacing the control unit, check the input and output and functions of the component parts. • Do not apply ex ...

    The oil pressure warning lamp does not turn on
    Description The oil pressure warning lamp stays off when the ignition switch is turned ON. Diagnosis Procedure 1.CHECK OIL PRESSURE WARNING LAMP Perform auto active test. Refer to PCS-12, "Diagnosis Description" (with I-KEY) or PCS-43, "Diagnosis Description" (without I- ...