Nissan Juke Owners Manual : Precautions on cruise control

•  If the cruise control system malfunctions, it will cancel automatically. The CRUISE indicator light on the meter panel will then blink to warn the driver.

•  If the engine coolant temperature becomes excessively high, the cruise control system will cancel automatically.

•  If the CRUISE indicator light blinks, turn the cruise control MAIN switch off and have the system checked by a NISSAN dealer.

• The CRUISE indicator light may blink when the cruise control MAIN switch is turned ON while pushing the ACCEL/RES, COAST/ SET or CANCEL switch. To properly set the cruise control system, perform the following procedures.

WARNING

Do not use the cruise control when driving under the following conditions:

•  when it is not possible to keep the vehicle at a set speed • in heavy traffic or in traffic that varies in speed •  on winding or hilly roads • on slippery roads (rain, snow, ice, etc.) •  in very windy areas

Doing so could cause a loss of vehicle control and result in an accident.

CAUTION

On Manual Transmission (MT) models, do not shift into N (Neutral) without depressing the clutch pedal when the cruise control is set. Should this occur, depress the clutch pedal and turn the MAIN switch off immediately. Failure to do so may cause engine damage.

    Cruise control operations
    1. ACCEL/RES switch 2. COAST/SET switch 3. CANCEL switch 4. MAIN (ON·OFF) switch The cruise control allows driving at a speed between 25 to 89 MPH (40 to 144 km/h) without keeping your foot o ...

    Other materials:

    P0138 HO2S2
    DTC Logic DTC DETECTION LOGIC The heated oxygen sensor 2 has a much longer switching time between rich and lean than the air fuel ratio (A/ F) sensor 1. The oxygen storage capacity of the three way catalyst 1 causes the longer switching time. MALFUNCTION A To judge the malfunctions of hea ...

    P0087, P0088, P0090 FRP control system
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC P0087 or P0090 is displayed with DTC P1197, first perform the trouble diagnosis for DTC P1197. • DTC P0087 or P0090 may be displayed when running out of gas. DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has be ...

    12-volt battery saver system
    To preserve the operational integrity of your electric vehicle, an automated 12-volt battery saver system is integrated into the vehicle's power management logic. When all the following specific operating conditions are simultaneously met and sustained for a predetermined perio ...