Nissan Juke Service and Repair Manual : Engine smokes when revved

Description

CHART 20: ENGINE SMOKES WHEN REVVED

Diagnosis Procedure

1.CHECK ENGINE OIL

Check the grade of engine oil. Refer to LU-25, "Inspection".

Is the inspection result normal? YES >> GO TO 2.

NO >> Replace engine oil. Refer to LU-26, "Refilling".

2.CHECK ENGINE OIL LEVEL

Is the engine oil level correct? Yes or No Yes >> GO TO 3.

No >> Top up the oil.

3.CHECK ECM POWER SUPPLY AND GROUND CIRCUIT

Check ECM power supply and ground circuit. Refer to EC-908, "Component Inspection".

Is the inspection result normal? YES >> GO TO 4.

NO >> Repair or replace harness or connector.

4.CHECK WIRING HARNESS

Visually check the condition of the engine wiring harness.

Is the inspection result normal? YES >> GO TO 5.

NO >> Repair or replace harness or connector.

5.CHECK MASS AIR FLOW SENSOR

Check mass air flow sensor. Refer to EC-902, "Component Inspection".

Is the inspection result normal? YES >> INSPECTION END

NO >> Repair or replace.

    Engine emits blue smoke
    Description CHART 19: ENGINE EMITS BLUE SMOKE Diagnosis Procedure 1.CHECK ENGINE OIL Check the grade of engine oil. Refer to LU-33, "Inspection". Is the inspection result normal? YES ...

    Engine emits white smoke (especially when starting)
    Description CHART 21: ENGINE EMITS WHITE SMOKE (ESPECIALLY WHEN STARTING) Diagnosis Procedure 1.CHECK FUEL Check that the fuel reservoir is correctly filled and with the right fuel. >> GO ...

    Other materials:

    B2630, B2631 sunload sensor
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC is displayed along with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to HAC- 51, "DTC Logic". • If DTC is displayed along with DTC U1010, first perform the trouble diagnosis for DTC U1010. HAC-52, "DTC L ...

    Door lock status indicator
    Component Function Check 1.CHECK FUNCTION 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “DOOR LOCK IND” in “ACTIVE TEST” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES >> Doo ...

    Component parts
    Charging system CHARGING SYSTEM : Component Parts Location 1. Charge warning lamp (On the combination meter) 2. Alternat CHARGING SYSTEM : Component Description Power generation voltage variable control system POWER GENERATION VOLTAGE VARIABLE CONTROL SYSTEM : Component Parts Location N ...