Nissan Juke Service and Repair Manual : Positive crankcase ventilation

Inspection

1.CHECK PCV VALVE

With engine running at idle, remove PCV valve from rocker cover. A properly working valve makes a hissing noise as air passes through it. A strong vacuum should be felt immediately when a finger is placed over valve inlet.

Is the inspection result normal? YES >> INSPECTION END

NO >> Replace PCV valve.

Removal and installation


    Evaporative emission system
    Inspection 1. Visually inspect EVAP vapor lines for improper attachment and for cracks, damage, loose connections, chafing and deterioration. 2. Check EVAP canister as follows: a. Block port (A) ...

    Other materials:

    Luggage room lamp
    Exploded View 1. Bulb housing 2. Bulb 3. Lens : Pawl Removal and Installation CAUTION: Disconnect the battery cable from negative terminal or remove the fuse. REMOVAL 1. Insert a remover tool (A) into the gap between luggage room lamp and luggage side lower finisher RH. 2. Disengage l ...

    P1722 vehicle speed
    Description The vehicle speed signal is transmitted from ABS actuator and electric unit (control unit) to TCM by CAN communication line. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: If “DTC CONFIRMATION PROCEDURE” has ...

    Drive pinion
    Exploded View 1. Pinion lock nut 2. Companion flange 3. Drive pion oil seal 4. Pinon rear bearing 5. Transfer case 6. Gasket 7. Filler plug 8. Collapsible spacer 9. Drive pinion adjust shim 10. Drive pinion 11. Pinion front bearing 12. Ring gear 13. Ring gear shaft 14. Ring ...