Speed limiter main switch

Component Function Check 1.CHECK SPEED LIMITER MAIN SWITCH FUNCTION With CONSULT-III 1. Turn ignition switch ON. 2. Select “ENGINE” using CONSULT-III. 3. Select “SL MAIN SW” in “DATA MO ...

Engine control system symptoms

Symptom Table SYSTEM — BASIC ENGINE CONTROL SYSTEM 1 - 6: The numbers refer to the order of inspection. (continued on next table) SYSTEM — ENGINE MECHANICAL & OTHER 1 - 6: The ...

Other materials:

Seat belt buckle switch signal circuit (driver side)
Component Function Check 1.CHECK COMBINATION METER INPUT SIGNAL Select the “Data Monitor” for the “METER/M&A” and check the “BUCKLE SW” monitor value. BUCKLE SW When driver seat belt is fastened : Off When driver seat belt is unfastened : On >> INSPECTION END Diagnosis ...

Fuel pressure
Work Procedure FUEL PRESSURE RELEASE With CONSULT-III 1. Turn ignition switch ON. 2. Perform “FUEL PRESSURE RELEASE” in “WORK SUPPORT” mode of “ENGINE” using CONSULT-III. 3. Start engine. 4. After engine stalls, crank it two or three times to release all fuel pressure. 5. Tur ...

Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always us ...