Nissan Juke Service and Repair Manual : P0863 TCM communication

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

>> GO TO 2.

2.CHECK DTC DETECTION

1. Turn ignition switch ON.With CONSULT-III


1. Turn ignition switch ON.

2. Check the DTC.

Is “P0863” detected? YES >> Go to TM-430, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.CHECK INTERMITTENT INCIDNT

Refer to GI-42, "Intermittent Incident".

Is the inspection result normal? YES >> Replace the TCM. Refer to TM-490, "Removal and Installation".

NO >> Repair or replace the malfunctioning parts.

    P0848 transmission fluid pressure SEN/SW B
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, the ignition switch OFF and wait for at ...

    P0962 pressure control solenoid A
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for a ...

    Other materials:

    Rocker cover
    Exploded View 1. Blow-by hose 2. Rocker cover 3. Gasket 4. Camshaft position sensor 5. O-ring A. To turbocharger air inlet pipe : N·m (kg-m, in-lb) : Always replace after every disassembly. Removal and Installation REMOVAL 1. Remove air cleaner case. Refer to EM-280, "Explode ...

    B1090, B1091, B1092, B1093, B1094, B1095 diagnosis sensor unit
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning la ...

    SRS air bag warning lamp does not turn off
    Diagnosis Procedure 1.CHECK AIR BAG MODULE AND SEAT BELT PRE-TENSIONER Check the deployment of air bag module. Is air bag module deployed? YES >> Replace the malfunctioning parts. NO >> GO TO 2. 2.CHECK AIR BAG FUSE Check 10 A fuse [No.2, located in fuse block (J/B)]. Is ...