Normal operating condition

Description FUEL CUT CONTROL (AT NO LOAD AND HIGH ENGINE SPEED) If the engine speed is above 2,400 rpm under no load (for example, the shift lever position is neutral and engine speed is over 2,4 ...

Ignition timing

Inspection 1.CHECK IGNITION TIMING 1. Attach timing light to loop wire as shown. 1. Loop wire A. Timing light B. Timing indicator 2. Check ignition timing. >> INSPECTION END ...

Other materials:

B2603 shift position
DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B2603 is displayed with DTC B2601, first perform the trouble diagnosis for DTC B2601. Refer to SEC-79, "DTC Logic". DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1 1. Shift the selector lever to the P position. 2. ...

U1402 engine speed signal
DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.PERFORM ECM SELF DIAGNOSIS Using CONSULT-III, check the “self diagnosis result” of “ENGINE” and repair or replace any malfunctioning parts. >> • Refer to EC-108, "DTC Index". (MR16DDT) • Refer to EC-522, &qu ...

Thermo control amplifier
Component Function Check 1.CHECK A/C ON SIGNAL With CONSULT-III 1. Turn ignition switch ON. 2. Select “AIR CONDITIONER” of “BCM” using CONSULT-III. 3. Select “THERMO AMP” in “DATA MONITOR” mode, and check status under the following condition. Is the inspection result normal ...