Nissan Juke Service and Repair Manual : Description

This vehicle has both new standard based on ISO* and previous standard bolts/nuts. There are some differences between these two types of bolts/ nuts; shape of the head, grade of strength, hexagonal width across flats and the standard tightening torque.

• For guidance in discriminating, refer to GI-19, "Tightening Torque Table (New Standard Included)".

• The new standard machine screws and tapping screws have a head of ISO standard torx recess.

• If the tightening torque is not described in the description or figure, refer to GI-19, "Tightening Torque Table (New Standard Included)".

*ISO: International Organization for Standardization

    Tightening Torque Table (New Standard Included)
    CAUTION: • The special parts are excluded. • The bolts/nuts in these tables have a strength (discrimination) number/symbol assigned to the head or the like. As to the relation between the str ...

    Other materials:

    Diagnosis system (BCM) (with intelligent key system)
    Common item COMMON ITEM : CONSULT-III Function (BCM - COMMON ITEM) APPLICATION ITEM CONSULT-III performs the following functions via CAN communication with BCM. SYSTEM APPLICATION BCM can perform the following functions for each system. NOTE: It can perform the diagnosis modes except the fo ...

    Engine stand setting
    NOTE: Explained here is how to disassemble with engine stand supporting transaxle surface. When using different type of engine stand, note with difference in steps and etc. 1. Remove the engine and the transaxle assembly from the vehicle, and separate the transaxle from the engine. Refer t ...

    Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
    NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always us ...