Nissan Juke Service and Repair Manual : Front wheel hub and knuckle

Inspection

COMPONENT PART

Check that the mounting conditions (looseness, backlash) of each component and component conditions (wear, damage) are normal.

WHEEL HUB ASSEMBLY (BEARING-INTEGRATED TYPE)

Check the following items, and replace the part if necessary.

• Move wheel hub assembly in the axial direction by hand. Check there is no looseness of wheel bearing.

Axial end play : Refer to FAX-90, "Wheel Bearing".

• Rotate wheel hub assembly and check there is no unusual noise or other irregular conditions. If there is any of irregular conditions, replace wheel hub assembly.

    Front drive shaft
    Inspection Check the following items, and replace the part if necessary. • Check drive shaft mounting point and joint for looseness and other damage. CAUTION: Replace entire drive shaft asse ...

    Other materials:

    Front washer nozzle and tube
    Exploded View LHD models 1. Front washer nozzle LH 2. Front washer nozzle RH 3. Cowl top cover 4. Front washer tube (tank side) 5. Front washer tube RH 6. Front washer tube LH : Vehicle front Hydraulic Layout 1. Front washer nozzle 2. Check valve 3. Front washer 4. Washer tank ...

    Service data and specifications (SDS)
    Idle Speed *: Under the following conditions • A/C switch: OFF • Electric load: OFF (Lights, heater fan & rear window defogger) • Steering wheel: Kept in straight-ahead position Ignition Timing *: Under the following conditions • A/C switch: OFF • Electric load: OFF (Lights ...

    Key switch
    Component Function Check 1.CHECK FUNCTION 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “KEY ON SW” in “DATA MONITOR” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES >> Key sw ...