Nissan Juke Service and Repair Manual : Front drive shaft

Inspection

Check the following items, and replace the part if necessary.

• Check drive shaft mounting point and joint for looseness and other damage.

CAUTION:
Replace entire drive shaft assembly when noise or vibration occurs from drive shaft.

• Check boot for cracks and other damage.

    Front wheel hub and knuckle
    Inspection COMPONENT PART Check that the mounting conditions (looseness, backlash) of each component and component conditions (wear, damage) are normal. WHEEL HUB ASSEMBLY (BEARING-INTEGRATED ...

    Other materials:

    P0706 transmission range sensor A
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test. >> GO TO 2. 2.PERFORM DTC CONFIRMATION ...

    Camshaft valve clearance
    Inspection and Adjustment INSPECTION Perform inspection as follows after removal, installation or replacement of camshaft or valve-related parts, or if there is unusual engine conditions regarding valve clearance. 1. Remove rocker cover. Refer to EM-178, "Removal and Installation". ...

    Symptom diagnosis
    SYSTEM SYMPTOM Symptom Table The diagnostics item numbers show the sequence for inspection. Inspect in order from item 1. ...