Front drive shaft

Inspection Check the following items, and replace the part if necessary. • Check drive shaft mounting point and joint for looseness and other damage. CAUTION: Replace entire drive shaft asse ...

Front wheel hub and K

Exploded View 1. Steering knuckle 2. Splash guard 3. Hub bolt 4. Wheel hub assembly (Bearing-integrated type) 5. Disc rotor 6. Wheel hub lock nut 7. Adjusting cap 8. Cotter pin A. Tigh ...

Other materials:

B2190 nats antenna AMP
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III. Is DTC detected? YES >> Refer to SEC-200, "Diagnosis Procedure". N ...

Engine stand setting
NOTE: Explained here is how to disassemble with engine stand supporting transaxle surface. When using different type of engine stand, note with difference in steps and etc. 1. Remove the engine and the transaxle assembly from the vehicle, and separate the transaxle from the engine. Refer t ...

Engine stalling
Description CHART 7: ENGINE STALLING Diagnosis Procedure 1.CHECK FUEL Check that the fuel reservoir is correctly filled and with the right fuel. >> GO TO 2. 2.CHECK ECM POWER SUPPLY AND GROUND CIRCUIT Check ECM power supply and ground circuit. Refer to EC-885, "Diagnosis Proc ...