Nissan Juke Service and Repair Manual : Turbocharger (If Equipped)

The turbocharger turbine revolves at extremely high speeds and becomes very hot. Therefore, it is essential to maintain a clean supply of oil flowing through the turbocharger and to follow all required maintenance instructions and operating procedures.

• Always use the recommended oil. Follow the instructions for proper time to change the oil and proper oil level.

• Avoid accelerating engine to a high rpm immediately after starting.

• If engine had been operating at high rpm for an extended period of time, let it idle for a few minutes prior to shutting if off.

Hoses


    Multiport Fuel Injection System or Engine Control System
    • Before connecting or disconnecting any harness connector for the multiport fuel injection system or ECM: Turn ignition switch to “OFF” position. Disconnect negative battery terminal. Otherwise, ...

    Hoses
    HOSE REMOVAL AND INSTALLATION • To prevent damage to rubber hose, do not pry off rubber hose with tapered tool or screwdriver. • To reinstall the rubber hose securely, check that hose insertion ...

    Other materials:

    Rear-facing child restraint installation using LATCH
    Refer to all Warnings and Cautions in the “Child safety” and “Child restraints” sections before installing a child restraint. Follow these steps to install a rear-facing child restraint using the LATCH system: 1. Position the child restraint on the seat. Always follow the child restraint manufa ...

    P1778 step motor
    Description • The step motor's 4 aspects of ON/OFF change according to the signal from TCM. As a result, the flow of line pressure to primary pulley is changed and pulley ratio is controlled. • This diagnosis item is detected when electrical system is OK, but mechanical system is NG. • This ...

    B26F8 BCM
    DTC Logic DTC DETECTION LOGIC NOTE: DTC B26F8 can be detected even though the related circuit is not used in this vehicle. DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON and wait 1 second. 2. Check DTC in “Self Diagnostic Result” mode of “BCM” u ...