Nissan Juke Service and Repair Manual : Precautions
- Description
- Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
- Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
- Precaution for Procedure without Cowl Top Cover
- General Precautions
- Three Way Catalyst
- Multiport Fuel Injection System or Engine Control System
- Turbocharger (If Equipped)
- Hoses
- Engine Oils
- Air Conditioning
- Fuel
Vehicle information
Identification information
Japan production models
JAPAN PRODUCTION MODELS : Model Variation
Model variation code (Prefix and suffix designations)
JAPAN PRODUCTION MODELS : Information About I ...
Description
Observe the following precautions to ensure safe and proper servicing.
These precautions are not
described in each individual section. ...
Other materials:
Rear disc brake
Brake pad : Exploded View
1. Sliding pin bolt
2. Cylinder body
3. Inner shim cover
4. Inner shim
5. Inner pad (with pad wear sensor)
6. Pad retainer
7. Torque member
8. Outer pad
9. Outer shim
10. Outer shim cover
1 Apply rubber grease.
2: Apply MOLYKOTE® AS880N or
silicone-bas ...
Multiport Fuel Injection System or Engine Control System
• Before connecting or disconnecting any harness connector for the
multiport fuel injection system or ECM:
Turn ignition switch to “OFF” position.
Disconnect negative battery terminal. Otherwise, there may be damage to ECM.
• Before disconnecting pressurized fuel line from fuel pump to injecto ...
C1115 wheel sensor
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn
ignition switch OFF and
wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
With CONSULT ...