Nissan Juke Service and Repair Manual : Terms

The captions WARNING and CAUTION warn you of steps that must be followed to prevent personal injury and/or damage to some part of the vehicle.

WARNING indicates the possibility of personal injury if instructions are not followed.

CAUTION indicates the possibility of component damage if instructions are not followed.

BOLD TYPED STATEMENTS except WARNING and CAUTION give you helpful information.

Standard value: Tolerance at inspection and adjustment.

Limit value: The maximum or minimum limit value that should not be exceeded at inspection and adjustment.

    Description
    This volume explains Removal, Disassembly, Installation, Inspection and Adjustment and Trouble Diagnoses. ...

    Units
    The UNITS given in this manual are primarily expressed as the SI UNIT (International System of Unit), and alternatively expressed in the metric system and in the yard/pound system. Also with r ...

    Other materials:

    Take away warning does not operate
    Diagnosis Procedure 1.CHECK DTC WITH BCM AND COMBINATION METER Check that DTC is not detected with BCM and combination meter. Is the inspection result normal? YES >> GO TO 2. NO-1 >> Refer to BCS-67, "DTC Index". (BCM) NO-2 >> Refer to MWI-36, "DTC Index&qu ...

    P0745 pressure control solenoid A
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE NOTE: If DTC CONFIRMATION PROCEDURE has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test. After the repair, perform the following procedure to confirm the mal ...

    Wheel Alignment
    2WD Measure value under unladen*2 conditions. *1: A difference when assuming the left side a standard. *2: Fuel, engine coolant and lubricant are full. Spare tire, jack, hand tools and mats are in designated positions. 4WD Measure value under unladen*2 conditions. *1: A differenc ...