Nissan Juke Service and Repair Manual : Abbreviations

Abbreviation List

The following ABBREVIATIONS are used:





Tightening torque of standard bolts


    Connector Information/Explanation of Option Abbreviation
    CONNECTOR LIST Connector information and harness layout are described in “POWER SUPPLY, GROUND & CIRCUIT ELEMENTS” Section. EXPLANATION OF OPTION ABBREVIATION HOW TO USE CONNECTOR INFORM ...

    Other materials:

    Throttle valve closed position learning
    Description Throttle Valve Closed Position Learning is a function of ECM to learn the fully closed position of the throttle valve by monitoring the throttle position sensor output signal. It must be performed each time harness connector of electric throttle control actuator or ECM is disconne ...

    Normal operating condition
    Description FUEL CUT CONTROL (AT NO LOAD AND HIGH ENGINE SPEED) If the engine speed is above 1,800 rpm under no load (for example, the selector lever position is neutral and engine speed is over 1,800 rpm) fuel will be cut off after some time. The exact time when the fuel is cut off varies b ...

    C1130 engine signal
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.CHECK DTC DETECTION With CONSULT ...