Nissan Juke Service and Repair Manual : Door does not lock/unlock with driver side door lock knob or door key cylinder

Nissan Juke Service and Repair Manual / Door & Lock type 2 / Symptom diagnosis / Door does not lock/unlock with driver side door lock knob or door key cylinder

Diagnosis Procedure

1.CHECK POWER DOOR LOCK OPERATION

Check power door lock operation.

Does door lock/unlock with door lock and unlock switch? YES >> GO TO 2.

NO >> Refer to DLK-254, "Component Function Check".

2.CHECK UNLOCK SENSOR

Check unlock sensor.

Refer to DLK-270, "Component Function Check".

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace the malfunctioning parts.

3.REPLACE BCM

1. Replace BCM. Refer to BCS-93, "Removal and Installation".

2. Confirm the operation after replacement.

Is the result normal? YES >> INSPECTION END

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    Door does not lock/unlock with door request switch
    All door request switches ALL DOOR REQUEST SWITCHES : Description All doors do not lock/unlock using all door request switches. ALL DOOR REQUEST SWITCHES : Diagnosis Procedure 1.CHECK REMOTE KEYLE ...

    Door does not lock/unlock with door lock and unlock switch
    All door ALL DOOR : Description All doors do not lock/unlock using door lock and unlock switch. ALL DOOR : Diagnosis Procedure 1.CHECK DOOR LOCK AND UNLOCK SWITCH Check door lock and unlock switc ...

    Other materials:

    Periodic maintenance
    IDLE SPEED Inspection 1.CHECK IDLE SPEED With CONSULT-III Check idle speed in “DATA MONITOR” mode with CONSULT-III. With GST Check idle speed with Service $01 of GST. Without CONSULT-III Check idle speed by installing the pulse type tachometer clamp on the loop wire or on suitable high ...

    Structure and operation
    Sectional View 1. 3rd input gear 2. 3rd-4th synchronizer hub assembly 3. 4th input gear 4. 5th input gear 5. 5th-6th synchronizer hub assembly 6. 6th input gear 7. Transaxle case 8. 6th main gear 9. 5th main gear 10. 4th main gear 11. 3rd main gear 12. 2nd main gear 13. 1st-2n ...

    P0711 transmission fluid temperature sensor A
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test. >> GO TO 2. 2.PERFORM DTC CONFIRMATION ...