Nissan Juke Service and Repair Manual : Inspection

LEVEL

• Check that the reservoir tank engine coolant level is within the “MIN” to “MAX” when the engine is cool.

A : MAX
B : MIN

• Adjust the engine coolant level if necessary.

LEAKAGE


LEAKAGE

• To check for leakage, apply pressure to the cooling system with the radiator cap tester (commercial service tool) (A) and the radiator cap tester adapter (commercial service tool) (B).

Testing pressure: Refer to CO-54, "Radiator".

WARNING:
Never remove radiator cap when engine is hot. Serious burns may occur from high-pressure engine coolant escaping from radiator.

CAUTION:
Higher test pressure than specified may cause radiator damage.

NOTE:

In a case that engine coolant decreases, replenish radiator with engine coolant.

• If anything is found, repair or replace damaged parts.

Draining


    Periodic maintenance
    ENGINE COOLANT ...

    Draining
    WARNING: • Never remove radiator cap when engine is hot. Serious burns may occur from high-pressure engine coolant escaping from radiator. • Wrap a thick cloth around the radiator cap. Slowly ...

    Other materials:

    Key reminder function does not operate
    Diagnosis Procedure 1.CHECK DOOR LOCK AND UNLOCK SWITCH Check door lock and unlock switch. Refer to DLK-520, "Component Function Check". Is the inspection result normal? YES >> GO TO 2. NO >> Repair or replace the malfunctioning parts. 2.CHECK KEY SWITCH Check k ...

    Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
    NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always us ...

    P0031, P0032 A/F sensor 1 heater
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait wait at least 10 seconds before conducting the next test. TESTING CONDITION: Before performing the following p ...