Nissan Juke Service and Repair Manual : Door does not lock/unlock with intelligent key

Nissan Juke Service and Repair Manual / Door & Lock Type 1 / Symptom diagnosis / Door does not lock/unlock with intelligent key

Diagnosis Procedure

1.CHECK DTC WITH BCM AND TCM

Check that DTC is not detected with BCM and TCM.

Is the inspection result normal? YES >> GO TO 2.

NO-1 >> Refer to BCS-67, "DTC Index". (BCM) NO-2 >> Refer to TM-171, "DTC Index" (RE0F10B models) or TM-366, "DTC Index" (RE0F11A models).

(TCM)

2.CHECK POWER DOOR LOCK OPERATION

Check door lock/unlock using door lock and unlock switch.

Does door lock/unlock using door lock and unlock switch? YES >> GO TO 3.

NO >> Refer to DLK-79, "DRIVER SIDE : Component Function Check".

3.CHECK REMOTE KEYLESS ENTRY RECEIVER

Check remote keyless entry receiver.

Refer to DLK-95, "Component Function Check".

Is the inspection result normal? YES >> GO TO 4.

NO >> Repair or replace the malfunctioning parts.

4.CHECK INTELLIGENT KEY

Check Intelligent Key.

Refer to DLK-91, "Component Function Check".

Is the inspection result normal? YES >> GO TO 5.

NO >> Repair or replace the malfunctioning parts.

5.REPLACE BCM

1. Replace BCM. Refer to BCS-93, "Removal and Installation".

2. Confirm the operation after replacement.

Is the result normal? YES >> INSPECTION END

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    Door does not lock/unlock with door lock and unlock switch
    All door ALL DOOR : Description All doors do not lock/unlock using door lock and unlock switch. ALL DOOR : Diagnosis Procedure 1.CHECK DOOR LOCK AND UNLOCK SWITCH Check door lock and unlock switc ...

    Ignition position warning function does not operate
    Diagnosis Procedure 1.CHECK DTC WITH BCM Check that DTC is not detected with BCM. Is the inspection result normal? YES >> GO TO 2. NO >> Refer to BCS-67, "DTC Index". ...

    Other materials:

    C1606 EPS motor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE W ...

    Meters and gauges
    1. Tachometer 2. Engine coolant temperature gauge 3. Vehicle information display — Odometer/twin trip odometer — Trip computer — Torque vectoring AWD (AWD model) — Outside air temperature 4. Fuel gauge 5. Speedometer 6. Warning/indicator lights 7. Instrument brightness control kn ...

    Microphone signal circuit
    Description Power is supplied from NAVI control unit to microphone. The microphone transmits the sound voice to the NAVI control unit. Diagnosis Procedure 1.CHECK CONTINUITY BETWEEN NAVI CONTROL UNIT AND MICROPHONE CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect NAVI control unit connecto ...