Nissan Juke Service and Repair Manual : Ignition position warning function does not operate

Nissan Juke Service and Repair Manual / Door & Lock Type 1 / Symptom diagnosis / Ignition position warning function does not operate

Diagnosis Procedure

1.CHECK DTC WITH BCM

Check that DTC is not detected with BCM.

Is the inspection result normal? YES >> GO TO 2.

NO >> Refer to BCS-67, "DTC Index".

2.CHECK POWER DOOR LOCK OPERATION

Check power door lock operation.

Does door lock/unlock with door lock and unlock switch? YES >> GO TO 3.

NO >> Refer to DLK-79, "DRIVER SIDE : Component Function Check".

3.CHECK DOOR SWITCH

Check door switch.

Refer to DLK-87, "Component Function Check".

Is the inspection result normal? YES >> GO TO 4.

NO >> Repair or replace the malfunctioning parts.

4.CHECK UNLOCK SENSOR

Check unlock sensor.

Refer to DLK-104, "Component Function Check".

Is the inspection result normal? YES >> GO TO 5.

NO >> Repair or replace the malfunctioning parts.

5.REPLACE BCM

1. Replace BCM. Refer to BCS-93, "Removal and Installation".

2. Confirm the operation after replacement.

Is the result normal? YES >> INSPECTION END

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    Door does not lock/unlock with intelligent key
    Diagnosis Procedure 1.CHECK DTC WITH BCM AND TCM Check that DTC is not detected with BCM and TCM. Is the inspection result normal? YES >> GO TO 2. NO-1 >> Refer to BCS-67, "D ...

    Super lock does not operate
    All door ALL DOOR : Diagnosis Procedure 1.CHECK SUPER LOCK ACTUATOR Check front driver side super lock actuator. Refer to DLK-99, "DRIVER SIDE : Component Function Check". Is the in ...

    Other materials:

    Key out interlock door unlock function does not operate
    Diagnosis Procedure 1.CHECK “AUTOMATIC LOCK/UNLOCK SELECT” SETTING IN “WORK SUPPORT” 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “AUTOMATIC LOCK/UNLOCK SELECT” in “WORK SUPPORT” mode. 3. Check “AUTOMATIC LOCK/UNLOCK SELECT” in “WORK SUPPORT”. Re ...

    RearView Monitor system limitations
    WARNING Listed below are the inherent technical system limitations of the RearView Monitor equipment. Failure to operate your vehicle in accordance with these specific system limitations could cause blind spots to go unnoticed, resulting in serious personal injury or death. The c ...

    Inspection
    OIL LEAKAGE Check rear final drive surrounding area (oil seal, drain plug, filler plug, and carrier case, etc.) for oil leakage. OIL LEVEL 1. Remove filler plug (1) and check oil level from filler plug mounting hole as shown in the figure. CAUTION: Never start engine while checking oil l ...