Unlock sensor

Component Function Check 1.CHECK FUNCTION 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “UNLK SEN -DR” in “DATA MONITOR” mode. 3. Check that the function operates normally acco ...

Door does not lock/unlock with door request switch

All door request switches ALL DOOR REQUEST SWITCHES : Description All doors do not lock/unlock using all door request switches. ALL DOOR REQUEST SWITCHES : Diagnosis Procedure 1.CHECK REMOTE KEYLE ...

Other materials:

B2195 anti-scanning
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III. Is DTC detected? YES >> Refer to SEC-62, "Diagnosis Procedure". NO >> ...

MR16DDT : Inspection and Adjustment
INSPECTION Magnetic Switch Check • Before starting to check, disconnect the battery cable from the negative terminal. • Disconnect “M” terminal of starter motor. 1. Continuity test [between “S” terminal (A) and switch body] B : “B” terminal C : “M” terminal • Replace magnetic switch if co ...

B1090, B1091, B1092, B1093, B1094, B1095 diagnosis sensor unit
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp statu ...