Nissan Juke Service and Repair Manual : Key reminder function does not operate

Diagnosis Procedure

1.CHECK DTC WITH BCM

Check that DTC is not detected with BCM.

Is the inspection result normal? YES >> GO TO 2.

NO >> Refer to BCS-67, "DTC Index".

2.CHECK “ANTI KEY LOCK IN FUNCTI” SETTING IN “WORK SUPPORT”

1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III.

2. Select “ANTI KEY LOCK IN FUNCTI” in “WORK SUPPORT” mode.

3. Check “ANTI KEY LOCK IN FUNCTI” in “WORK SUPPORT”.

Refer to DLK-43, "INTELLIGENT KEY : CONSULT-III Function (BCM - INTELLIGENT KEY) (With Super Lock)".

Is the inspection result normal? YES >> GO TO 3.

NO >> Set “ANTI KEY LOCK IN FUNCTI” in “WORK SUPPORT”.

3.CHECK DOOR SWITCH

Check door switch.

Refer to DLK-87, "Component Function Check".

Is the inspection result normal? YES >> GO TO 4.

NO >> Repair or replace the malfunctioning parts.

4.CHECK INSIDE KEY ANTENNA

Check inside key antenna.

• Instrument center: Refer to DLK-55, "DTC Logic".

• Console: Refer to DLK-57, "DTC Logic".

• Luggage room: Refer to DLK-59, "DTC Logic".

Is the inspection result normal? YES >> GO TO 5.

NO >> Repair or replace the malfunctioning parts.

5.CHECK UNLOCK SENSOR

Check unlock sensor.

Refer to DLK-104, "Component Function Check".

Is the inspection result normal? YES >> GO TO 6.

NO >> Repair or replace the malfunctioning parts.

6.REPLACE BCM

1. Replace BCM. Refer to BCS-93, "Removal and Installation".

2. Confirm the operation after replacement.

Is the result normal? YES >> INSPECTION END

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    Hazard and buzzer reminder does not operate
    Diagnosis Procedure 1.CHECK DTC WITH BCM AND COMBINATION METER Check that DTC is not detected with BCM and combination meter. Is the inspection result normal? YES >> GO TO 2. NO-1 >& ...

    Off position warning does not operate
    Diagnosis Procedure 1.CHECK DTC WITH BCM AND COMBINATION METER Check that DTC is not detected with BCM and combination meter. Is the inspection result normal? YES >> GO TO 2. NO-1 >& ...

    Other materials:

    A-bag branch line circuit
    Diagnosis Procedure WARNING: • Before servicing, turn ignition switch OFF, disconnect battery negative terminal, and wait 3 minutes or more. (To discharge backup capacitor.) • Never use unspecified tester or other measuring device. 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disco ...

    Output speed sensor
    Exploded View 1. Transaxle assembly 2. Output speed sensor 3. O-ring : Vehicle front : Always replace after every disassembly. : N·m (kg-m, in-lb) : Genuine NISSAN CVT Fluid NS-2 Removal and Installation REMOVAL 1. Disconnect battery cable from negative terminal. Refer to PG-124, &qu ...

    Removal and installation
    REAR WHEEL HUB Exploded View 1. Rear suspension beam 2. Rear brake assembly 3. Hub bolt 4. Wheel hub assembly (Bearing-integrated type) 5. Disc rotor 6. Plug : Always replace after every disassembly. : N·m (kg-m, ft-lb) Removal and Installation REMOVAL 1. Remove tires. Refer to W ...