Nissan Juke Service and Repair Manual : Door & Lock Type 1
- How to use this manual
- Precaution
- Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
- Precaution Necessary for Steering Wheel Rotation after Battery Dis
- Precaution for Procedure without Cowl Top Cover
- Work
- Preparation
- System description
- Component parts
- System (power door lock system)
- System (intelligent key system)
- Back door opener system
- Diagnosis system (BCM)
- ECU diagnosis information
- Wiring diagram
- Basic inspection
- DTC/circuit diagnosis
- B2621 inside antenna
- B2622 inside antenna
- B2623 inside antenna
- B2626 outside antenna
- B2627 outside antenna
- B2628 outside antenna
- Back door opener actuator
- Back door opener switch
- Back door request switch
- Buzzer (combination meter)
- Door lock actuator
- Door lock and unlock switch
- Door lock status indicator
- Door request switch
- Door switch
- Hazard function
- Intelligent key
- Intelligent key warning buzzer
- Key warning lamp
- Remote keyless entry receiver
- Shift P warning lamp
- Super lock actuator
- Unlock sensor
- Symptom diagnosis
- Door does not lock/unlock with door request switch
- Door does not lock/unlock with door key cylinder operation
- Door does not lock/unlock with door lock and unlock switch
- Door does not lock/unlock with intelligent key
- Ignition position warning function does not operate
- Super lock does not operate
- Anti-hijack function does not operate
- Back door does not opened
- Auto door lock operation does not operate
- Vehicle speed sensing auto lock operation does not operate
- IGN off interlock door unlock function does not operate
- P range interlock door lock/unlock function does not operate
- Hazard and buzzer reminder does not operate
- Key reminder function does not operate
- Off position warning does not operate
- P position warning does not operate
- ACC warning does not operate
- Take away warning does not operate
- Intelligent key low battery warning does not operate
- Door lock operation warning does not operate
- Key ID warning does not operate
- Door lock status indicator does not illuminate
- Squeak and rattle trouble diagnoses
- Removal and installation
Heated seat switch
Exploded View
1. Heated seat swich
2. Switch bracket
3. Console switch finisher
Removal and Installation
REMOVAL
CAUTION:
When removing and installing, use shop cloths to protect from damag ...
How to use this manual
APPLICATION NOTICE
Information
Check the vehicle type to use the service information in this section.
...
Other materials:
Checking engine coolant level
Check the coolant level in the reservoir when the engine is cold. If the coolant
level is below the MIN level 2 , open the reservoir cap and add coolant up to the
MAX level 1 . If the reservoir is empty, check the coolant level in the radiator
when the engine is cold. If there is insufficien ...
Symptom diagnosis
Squeak and rattle trouble diagnoses
Work Flow
CUSTOMER INTERVIEW
Interview the customer if possible, to determine the conditions that exist
when the noise occurs. Use the Diagnostic
Worksheet during the interview to document the facts and conditions when the
noise occurs and any of
the cu ...
B1081 seat belt Pre-tensioner RH
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAG RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning la ...
