Diagnosis system (BCM)

Common item : consult-III Function (BCM - COMMON ITEM) APPLICATION ITEM CONSULT-III performs the following functions via CAN communication with BCM. SYSTEM APPLICATION BCM can perform the follow ...

Wiring diagram

DOOR & LOCK SYSTEM Wiring Diagram For connector terminal arrangements, harness layouts, and alphabets in a (option abbreviation; if not described in wiring diagram), refer to GI-12, "Conn ...

Other materials:

Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always us ...

Draining
1. Start engine and let it run to warm up transaxle. 2. Stop engine. Remove drain plug (1) and gasket, using a socket [Commercial service tool] and then drain gear oil. 3. Set a gasket on drain plug and install it to clutch housing, using a socket [Commercial service tool]. CAUTION: Never re ...

Push-button ignition switch
Component Function Check 1.CHECK FUNCTION 1. Select “PUSH SW” in “Data Monitor” mode with CONSULT-III. 2. Check the push-button ignition switch signal under the following conditions. Is the indication normal? YES >> INSPECTION END. NO >> Go to PCS-108, "Diagnosis Pro ...