Nissan Juke Service and Repair Manual : Draining

1. Start engine and let it run to warm up transaxle.

2. Stop engine. Remove drain plug (1) and gasket, using a socket [Commercial service tool] and then drain gear oil.

3. Set a gasket on drain plug and install it to clutch housing, using a socket [Commercial service tool].

CAUTION:
Never reuse gasket.

4. Tighten drain plug to the specified torque. Refer to TM-33, "Exploded View".

Refilling


    Inspection
    OIL LEAKAGE Make sure that gear oil is not leaking from transaxle or around it. OIL LEVEL 1. Remove filler plug (1) and gasket from transaxle case. 2. Check the oil level from filler plug mounti ...

    Refilling
    1. Remove filler plug (1) and gasket from transaxle case. 2. Fill with new gear oil until oil level reaches the specified limit at filler plug mounting hole as shown in the figure. Oil grade and v ...

    Other materials:

    Door lock actuator
    Driver side DRIVER SIDE : Component Function Check 1.CHECK FUNCTION 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “DOOR LOCK” in “ACTIVE TEST” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result no ...

    Diagnosis system (air bag)
    Description CAUTION: • Never use electrical test equipment on any circuit related to the SRS unless instructed in this Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or harness connectors. • Never repair, splice or modify the SRS wiring harness. ...

    P1612 chain of ECM-IMMU
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC P1612 is displayed with DTC U1000 (for BCM), first perform the trouble diagnosis for DTC U1000. Refer to BCS-153, "DTC Logic". • If DTC P1612 is displayed with DTC U1010 (for BCM), first perform the trouble diagnosis for DTC U1010 ...