Nissan Juke Service and Repair Manual : Refilling

1. Remove filler plug (1) and gasket from transaxle case.

2. Fill with new gear oil until oil level reaches the specified limit at filler plug mounting hole as shown in the figure.

Oil grade and viscosity : Refer to MA-13, "Fluids and Lubricants".

Oil capacity : Refer to TM-63, "General Specifications

3. After refilling gear oil, check the oil level. Refer to TM-22, "Inspection".

4. Set a gasket on filler plug and then install it to transaxle case.

CAUTION:
Never reuse gasket.

5. Tighten filler plug to the specified torque. Refer to TM-33, "Exploded View".

Removal and installation


    Draining
    1. Start engine and let it run to warm up transaxle. 2. Stop engine. Remove drain plug (1) and gasket, using a socket [Commercial service tool] and then drain gear oil. 3. Set a gasket on drain plu ...

    Other materials:

    Combination switch output circuit
    Diagnosis Procedure 1.CHECK OUTPUT 1 - 5 CIRCUIT FOR OPEN 1. Turn ignition switch OFF. 2. Disconnect BCM and combination switch connectors. 3. Check continuity between BCM harness connector and combination switch harness connector. Does continuity exist? YES >> GO TO 2. NO >> ...

    P0200 fuel injector
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK FUEL INJECTOR POWER SUPPLY CIRCUIT FOR OPEN AND SHORT 1. Turn ignition switch OFF. 2. Disconnect ECM harness connector. 3. Disconnect fuel injector harness connector. 4. Check the continuity between fuel injector harness connector an ...

    Component parts
    Component Parts Location 1. Intelligent Key warning buzzer 2. Remote keyless entry receiver 3. Inside key antenna (instrument center) 4. TCM Refer to TM-133, "CVT CONTROL SYSTEM : TCM" (RE0F10B models) or TM-316, "CVT CONTROL SYSTEM : TCM" (RE0F11A models) 5. Push-bu ...