Refilling

1. Remove filler plug (1) and gasket from transaxle case. 2. Fill with new gear oil until oil level reaches the specified limit at filler plug mounting hole as shown in the figure. Oil grade and v ...

Side oil seal

Removal and Installation REMOVAL 1. Remove front drive shafts. Refer to FAX-53, "Removal and Installation". 2. Remove differential side oil seals (1) from clutch housing and transaxle ca ...

Other materials:

Key interlock cable
Exploded View 1. CVT shift selector assembly 2. Key interlock cable A: Key cylinder B: Clip C: Clip Removal and Installation REMOVAL CAUTION: Always apply the parking brake before performing removal and installation. 1. Shift the selector lever to the “P” position. 2. Remove the ...

Daytime running light relay circuit
Component Function Check 1.CHECK DAYTIME RUNNING LIGHT OPERATION CONSULT-III ACTIVE TEST 1. Select “EXTERNAL LAMPS” of IPDM E/R active test item. 2. With operating the test item, check that parking lamp, tail lamp and license plate lamp are turned ON. TAIL : Parking lamp, tail lamp and li ...

Back door opener actuator
Component Function Check 1.CHECK FUNCTION 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “TRUNK/BACK DOOR” in “ACTIVE TEST” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES > ...