Nissan Juke Service and Repair Manual : Side oil seal
Removal and Installation
REMOVAL
1. Remove front drive shafts. Refer to FAX-53, "Removal and Installation".
2. Remove differential side oil seals (1) from clutch housing and transaxle case, using an oil seal remover.
CAUTION:
Never damage transaxle case and clutch housing.
INSTALLATION
Note the following, and install in the reverse order of removal.
• Install differential side oil seals (1) to clutch housing and transaxle case, using the drift [Stamping number: B.vi 1666-B] of the drift set [SST: KV32500QAA].
B : Transaxle case side C : Clutch housing side
Dimension “L1” : 5.7 – 6.3 mm (0.224 – 0.248 in) Dimension “L2” : 2.4 – 3.0 mm (0.094 – 0.118 in)
CAUTION:
• Never incline differential side oil seal.
• Never damage clutch housing and transaxle case.
Inspection
INSPECTION AFTER INSTALLATION
Check the oil level and oil leakage. Refer to TM-22, "Inspection".
Position switch
Removal and Installation
REMOVAL
1. Drain gear oil. Refer to TM-22, "Draining".
2. Disconnect position switch connector (A).
3. Remove position switch from transaxle case.
INSTALLATIO ...
Other materials:
Diagnosis system (IPDM E/R)
Diagnosis Description
AUTO ACTIVE TEST
Description
In auto active test mode, the IPDM E/R sends a drive signal to the following
systems to check their operation.
• Oil pressure warning lamp (only for K9K engine models)
• Rear window defogger
• Front wiper motor
• Parking lamp
• ...
I-BSI system limitations
WARNING
The following points outline critical operational limitations for the Intelligent Blind Spot Intervention (I-BSI) system. Failing to operate your Nissan Leaf in strict accordance with these limitations could result in an inappropriate system response, potentially leading to serious inju ...
Service data and specifications (SDS
Compressor
Lubricant
Refrigerant
Engine Idling Speed
Refer to EC-449, "Idle Speed".
Belt Tension
Refer to EM-20, "Checking". ...
