Work

• After removing and installing the opening/closing parts, be sure to carry out fitting adjustments to check their operational. • Check the lubrication level, damage, and wear of each part. If nec ...

System description

...

Other materials:

B1089 seat belt Pre-tensioner LH
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp statu ...

Keyfob ID registration
Description Perform the following procedure after BCM is replaced or when new keyfob ID is registered NOTE: When registering the keyfob ID, perform only one procedure to simultaneously register both ID (IMMOBILIZER ID and keyfob ID). Work Procedure 1.STEP 1 Close all doors. >> GO ...

Loading tips
•  The GVW must not exceed GVWR or GAWR as specified on the F.M.V.S.S./ C.M.V.S.S. certification label. • Do not load the front and rear axle to the GAWR. Doing so will exceed the GVWR. WARNING •  Properly secure all cargo with ropes or straps to help prevent it from sliding or shif ...