Squeak and rattle trouble diagnoses

Work Flow CUSTOMER INTERVIEW Interview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet during the interview to document the fa ...

Hood

Exploded View 1. Hood assembly 2. Hood bumper rubber 3. Radiator core seal 4. Hood bumper rubber 5. Clamp 6. Hood hinge 7. Grommet 8. Hood support rod : Clip : Pawl : Body grease Ho ...

Other materials:

EPS warning lamp
Component Function Check 1.CHECK THE ILLUMINATION OF THE EPS WARNING LAMP Check that the EPS warning lamp turns ON when ignition switch turns ON. Then, EPS warning lamp turns OFF after the engine is started. Is the inspection result normal? YES >> INSPECTION END NO >> Perform t ...

Refilling
1. Install reservoir tank if removed and radiator drain plug. CAUTION: Be sure to clean drain plug and install with new O-ring. Radiator drain plug : Refer to CO-42, "Exploded View". • If water drain plugs on cylinder block are removed, close and tighten them. Refer to EM-228, &quo ...

Exhaust manifold
Exploded View 1. Exhaust manifold cover 2. Harness bracket 3. Air fuel ratio sensor 1 4. Exhaust manifold stay 5. Heat insulator 6. Exhaust manifold 7. Exhaust manifold cover 8. Gasket : Engine front : Always replace after every disassembly. : N·m (kg-m, in-lb) : N·m (kg-m, ft- ...