Nissan Juke Service and Repair Manual : Inside key antenna

Instrument center

INSTRUMENT CENTER : Removal and Installation

REMOVAL

1. Remove the multi display unit. Refer to AV-125, "Removal and Installation".

2. Remove the inside key antenna (instrument center) (1) mounting clip (A), and then remove inside key antenna (instrument center).

CAUTION:
Be careful not to drop mounting clip (A) into instrument panel.

INSTALLATION


INSTALLATION

Install in the reverse order of removal.

Console

CONSOLE : Removal and Installation

REMOVAL

1. Remove the center console assembly. Refer to IP-23, "Removal and Installation".

2. Remove the inside key antenna (console) (1) mounting clip (A), and then remove inside key antenna (console).

INSTALLATION


INSTALLATION

Install in the reverse order of removal.

Luggage room

LUGGAGE ROOM : Exploded View

1. Inside key antenna (luggage room)


1. Inside key antenna (luggage room) 2. Clip

LUGGAGE ROOM : Removal and Installation: Do not reuse


LUGGAGE ROOM : Removal and Installation

REMOVAL

1. Remove the luggage floor finisher. Refer to INT-29, "Exploded View".

2. Remove the inside key antenna (luggage room) (1) mounting clip RH (A).

3. Disengage inside key antenna (luggage room) fixing clip using a


3. Disengage inside key antenna (luggage room) fixing clip using a flat-bladed screwdriver (A), and then pull out forward the inside key antenna (luggage room).

INSTALLATION


INSTALLATION

Install in the reverse order of removal.

CAUTION:
Visually check the clips for deformation and damage during installation.

Replace with new ones if necessary.

    Door switch
    Exploded View 1. Door switch 2. TORX bolt Removal and Installation REMOVAL Remove the TORX bolt (A), and then remove door switch (1). INSTALLATION Install in the reverse order of removal. ...

    Outside key antenna
    Driver side DRIVER SIDE : Removal and Installation REMOVAL Remove the driver side outside handle. Refer to DLK-176, "OUTSIDE HANDLE : Removal and Installation". INSTALLATION Install ...

    Other materials:

    Front grille
    Exploded View 1. Bumper fascia assembly 2. Front side grille RH 3. Front center grille 4. Emblem 5. Front side grille LH : Pawl Removal and Installation REMOVAL CAUTION: When remove front grilles (1) apply protective tape (A) on the bumper fascia (2) to protect the painted surface fr ...

    Interior room lamp control circuit
    Description Controls each interior room lamp (ground side) by PWM signal. NOTE: PWM signal control period is approximately 250 Hz (in the gradual brightening/dimming). Component Function Check CAUTION: Before performing the diagnosis, check that the following are normal. • Interior room l ...

    Remote keyless entry system (if so equipped)
    It is possible to lock/unlock all doors (including the lift gate), and activate the panic alarm by using the keyfob from outside the vehicle. Before locking the doors, make sure the key is not left in the vehicle. The keyfob can operate at a distance of approximately 33 ft (10 m) from the vehic ...