Nissan Juke Service and Repair Manual : Door switch

Exploded View

1. Door switch


1. Door switch
2. TORX bolt

Removal and Installation

REMOVAL

Remove the TORX bolt (A), and then remove door switch (1).

INSTALLATION


INSTALLATION

Install in the reverse order of removal.

    Fuel filler lid opener
    Exploded View 1. Fuel filler lid opener cable 2. Cable protector 3. Fuel filler lid lock assembly 4. Fuel filler lid assembly 5. Spring 6. Bumper rubber : Clip : Do not reuse Fuel fille ...

    Inside key antenna
    Instrument center INSTRUMENT CENTER : Removal and Installation REMOVAL 1. Remove the multi display unit. Refer to AV-125, "Removal and Installation". 2. Remove the inside key antenna ( ...

    Other materials:

    Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
    The Supplemental Restraint System such as ???AIR BAG??? and ???SEAT BELT PRE-TENSIONER???, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision. This system includes seat belt switch inputs and dual s ...

    Intelligent key warning buzzer
    Component Function Check 1.CHECK FUNCTION 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “OUTSIDE BUZZER” in “ACTIVE TEST” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES >> Intelligent ...

    P062B ECM
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.INSPECTION START 1. Turn ignition switch ON. 2. Erase DTC. 3. Turn ignition switch OFF and wait for 20 seconds. 4. Turn ignition switch ON and perform the self-diagnosis. Is the DTC P062B displayed again? YES >> GO TO 2. NO &g ...