Intelligent key warning buzzer

Removal and Installation REMOVAL 1. Remove the Intelligent Key warning buzzer (1) mounting bolt (A), and then remove the Intelligent Key warning buzzer. INSTALLATION Install in the reverse orde ...

Intelligent key battery

Removal and Installation 1. Release the lock knob at the back of the Intelligent Key and remove the mechanical key. 2. Insert a flat-blade screwdriver (A) wrapped with a cloth into the slit of th ...

Other materials:

Rear window and outside mirror defroster switch
Type A Type B To defog/defrost the rear window glass and outside mirrors (if so equipped), start the engine and push the switch 1 on. The indicator light 2 will illuminate. Push the switch again to turn the defroster off. It will automatically turn off in approximately 15 minutes. CAUTIO ...

B1182 lap Pre-tensioner LH
DTC Logic DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAGNOSTIC RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp status. Refer to SRC ...

Assembly and Installation
• Use torque wrench to tighten bolts or nuts to specification. • When tightening nuts and bolts, as a basic rule, equally tighten in several different steps starting with the ones in center, then ones on inside and outside diagonally in this order. If the order of tightening is specified, do ...