Nissan Juke Service and Repair Manual : Intelligent key warning buzzer

Removal and Installation

REMOVAL

1. Remove the Intelligent Key warning buzzer (1) mounting bolt (A), and then remove the Intelligent Key warning buzzer.

INSTALLATION


INSTALLATION

Install in the reverse order of removal.

    Outside key antenna
    Driver side DRIVER SIDE : Removal and Installation REMOVAL Remove the driver side outside handle. Refer to DLK-176, "OUTSIDE HANDLE : Removal and Installation". INSTALLATION Install ...

    Remote keyless entry receiver
    Removal and Installation REMOVAL 1. Remove the glove box assembly. Refer to IP-13, "Removal and Installation". 2. Remove the remote keyless entry receiver (1) mounting bolt (A), and th ...

    Other materials:

    B1011, B1012, B1013, B1014, B1015 diagnosis sensor unit
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning la ...

    For side and rollover collision : When SRS is not activated in a collision
    CAUTION: Due to varying models and option levels, not all parts listed in the chart below apply to all vehicles. WORK PROCEDURE 1. Before performing any of the following steps, ensure that all vehicle body and structural repairs have been completed. 2. Check the SRS components and the rel ...

    Removal and installation
    MULTI DISPLAY UNIT Exploded View REMOVAL Refer to IP-12, "Exploded View". DISASSEMBLY 1. Silencer tape 2. Multi display unit 3. Silencer tape 4. Clip 5. Control finisher Removal and Installation REMOVAL Refer to IP-12, "Exploded View". CAUTION: • When per ...