Nissan Juke Service and Repair Manual : Intelligent key battery

Removal and Installation

1. Release the lock knob at the back of the Intelligent Key and remove the mechanical key.

2. Insert a flat-blade screwdriver (A) wrapped with a cloth into the slit of the corner and twist it to separate the upper part from the lower part.

CAUTION:
• Do not touch the circuit board or battery terminal.

• The key fob is water-resistant. However, if it does get wet, immediately wipe it dry.

3. Replace the battery with new one.


3. Replace the battery with new one.

Battery replacement :Coin-type lithium battery (CR2025)

4. Align the tips of the upper and lower parts, and then push them together until it is securely closed.

CAUTION:
• When replacing battery, keep dirt, grease, and other foreign materials off the electrode contact area.

• After replacing the battery, check that all Intelligent Key functions work normally.

Door & Lock type 2


    Remote keyless entry receiver
    Removal and Installation REMOVAL 1. Remove the glove box assembly. Refer to IP-13, "Removal and Installation". 2. Remove the remote keyless entry receiver (1) mounting bolt (A), and th ...

    Other materials:

    Combination switch input circuit
    Diagnosis Procedure 1.CHECK INPUT 1 - 5 CIRCUIT FOR OPEN 1. Turn ignition switch OFF. 2. Disconnect BCM and combination switch connectors. 3. Check continuity between BCM harness connector and combination switch harness connector. Does continuity exist? YES >> GO TO 2. NO >> ...

    Precaution
    Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the ...

    B1218, B1219, B1220, B1221, B1222, B1223 diagnosis sensor unit
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning la ...