Nissan Juke Owners Manual : Tire dressing

NISSAN does not recommend the use of tire dressings. Tire manufacturers apply a coating to the tires to help reduce discoloration of the rubber. If a tire dressing is applied to the tires, it may react with the coating and form a compound.

This compound may come off the tire while driving and stain the vehicle paint.

If you choose to use a tire dressing, take the following precautions:

•  Use a water-based tire dressing. The coating on the tire dissolves more easily with an oil-based tire dressing.

• Apply a light coat of tire dressing to help prevent it from entering the tire tread/ grooves (where it would be difficult to remove).

• Wipe off excess tire dressing using a dry towel. Make sure the tire dressing is completely removed from the tire tread/ grooves.

• Allow the tire dressing to dry as recommended by tire dressing manufacturer.

    Chrome parts
    Clean chrome parts regularly with a nonabrasive chrome polish to maintain the finish. ...

    Cleaning interior
    Occasionally remove loose dust from the interior trim, plastic parts and seats using a vacuum cleaner or soft bristled brush. Wipe the vinyl and leather surfaces with a clean, soft cloth dampened ...

    Other materials:

    Front fog lamp aiming adjustment
    Description PREPARATION BEFORE ADJUSTING NOTE: For details, refer to the regulations in your own country. Before performing aiming adjustment, check the following. • Adjust the tire pressure to the specification. • Fill with fuel, engine coolant and each oil. • Maintain the unloaded ...

    P0335 CKP sensor (POS)
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK GROUND CONNECTIONS 1. Turn ignition switch OFF. 2. Check ground connection E38. Refer to Ground inspection in GI-44, "Circuit Inspection". Is the inspection result normal? YES >> GO TO 2. NO >> Repair or ...

    P range interlock door lock/unlock function does not operate
    Diagnosis Procedure 1.CHECK “AUTOMATIC LOCK/UNLOCK SELECT” SETTING IN “WORK SUPPORT” 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “AUTOMATIC LOCK/UNLOCK SELECT” in “WORK SUPPORT” mode. 3. Check “AUTOMATIC LOCK/UNLOCK SELECT” in “WORK SUPPORT”. Re ...