Nissan Juke Service and Repair Manual : Back door lock

Exploded View

1. Back door lock assembly


1. Back door lock assembly 2. TORX bolt
3. Back door striker

: N·m (kg-m, ft-lb): Do not reuse
: Body grease: N·m (kg-m, ft-lb)
Door lock: Body grease


Door lock

DOOR LOCK : Removal and Installation

REMOVAL

1. Remove the back door lower finisher. Refer to INT-35, "BACK DOOR LOWER FINISHER : Removal and Installation".

2. Remove back door lock assembly mounting bolts.

3. Disconnect back door lock connector, and then remove back door lock assembly.

INSTALLATION

Note the following item, and install in the reverse order of removal.

CAUTION:
After installation, check back door open/close, and lock/unlock operation.

Emergency lever

EMERGENCY LEVER : Unlock procedures

UNLOCK PROCEDURES

NOTE

:
If back door lock cannot be unlocked due to a malfunction or battery discharge, follow the procedures to unlock back door.

1. Remove emergency lid. Refer to INT-36, "EMERGENCY LID : Removal and Installation".

2. From inside the vehicle, rotate emergency lever toward lower direction and unlock.

Fuel filler lid opener


    Rear door lock
    Exploded View 1. Outside handle assembly 2. Inside handle 3. TORX bolt 4. Door lock assembly 5. Rear door sealing screen : Clip : Pawl : Vehicle front : Do not reuse : N·m (kg-m, in-lb ...

    Fuel filler lid opener
    Exploded View 1. Fuel filler lid opener cable 2. Cable protector 3. Fuel filler lid lock assembly 4. Fuel filler lid assembly 5. Spring 6. Bumper rubber : Clip : Do not reuse Fuel fille ...

    Other materials:

    FM-AM-SAT radio with Compact Disc (CD) player (Type A)
    1. MUTE button 2. DISP (display)/TEXT button 3. FM·AM radio band select button 4. CD PLAY button 5. Radio station preset buttons 6. iPod® button 7. AUX (auxiliary)/SAT band select button 8. Audio display 9. CLOCK button 10. CD EJECT button 11. iPod® MENU button 12. SEEK/TRACK button ...

    Camshaft valve clearance
    Valve Clearance CHECKING AND ADJUSTING THE VALVE CLEARANCE 1. Install the tappet. 2. Install the camshaft. 3. Install the camshaft brackets. : 11 N·m (1.1 kg-m, 8 ft-lb) 4. Place the valves of the cylinder concerned at the “end of exhaust - beginning of inlet” position and check the clea ...

    Additional service when replacing transaxle assembly
    Description Perform the following work after the transaxle assembly is replaced. Erasing the calibration data • The TCM acquires calibration data (individual characteristic value) of each solenoid that is stored in the ROM assembly (in the control valve). This enables the TCM to perform ac ...