Nissan Juke Service and Repair Manual : Door lock operation warning does not operate

Nissan Juke Service and Repair Manual / Door & Lock Type 1 / Symptom diagnosis / Door lock operation warning does not operate

Diagnosis Procedure

1.CHECK DOOR LOCK FUNCTION

Check door lock function.

Does door lock/unlock using door request switch? YES >> GO TO 2.

NO >> Refer to DLK-85, "Component Function Check".

2.CHECK INTELLIGENT KEY WARNING BUZZER

Check Intelligent Key warning buzzer.

Refer to DLK-92, "Component Function Check".

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace the malfunctioning parts.

3.REPLACE BCM

1. Replace BCM. Refer to BCS-93, "Removal and Installation".

2. Confirm the operation after replacement.

Is the result normal? YES >> INSPECTION END

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    Intelligent key low battery warning does not operate
    Diagnosis Procedure 1.CHECK DTC WITH BCM AND COMBINATION METER Check that DTC is not detected with BCM and combination meter. Is the inspection result normal? YES >> GO TO 2. NO-1 >& ...

    Key ID warning does not operate
    Diagnosis Procedure 1.CHECK DTC WITH BCM AND COMBINATION METER Check that DTC is not detected with BCM and combination meter. Is the inspection result normal? YES >> GO TO 2. NO-1 >& ...

    Other materials:

    Event Data Recorders (EDR)
    Your Nissan Leaf is engineered with a sophisticated Event Data Recorder (EDR). The primary objective of this system is to capture and store technical data during specific crash or near-crash scenarios—such as instances where an airbag deploys or the vehicle sustains a significant impact with an ob ...

    Squeak and rattle trouble diagnoses
    Work Flow CUSTOMER INTERVIEW Interview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet during the interview to document the facts and conditions when the noise occurs and any of the customer's comments; refer to MIR-39, & ...

    Intelligent key
    Component Function Check 1.CHECK FUNCTION 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “RKE OPE COUN1” in “DATA MONITOR” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES >& ...