Nissan Juke Service and Repair Manual : Intelligent key low battery warning does not operate

Nissan Juke Service and Repair Manual / Door & Lock Type 1 / Symptom diagnosis / Intelligent key low battery warning does not operate

Diagnosis Procedure

1.CHECK DTC WITH BCM AND COMBINATION METER

Check that DTC is not detected with BCM and combination meter.

Is the inspection result normal? YES >> GO TO 2.

NO-1 >> Refer to BCS-67, "DTC Index". (BCM) NO-2 >> Refer to MWI-36, "DTC Index". (Combination meter)

2.CHECK “LO- BATT OF KEY FOB WARN” SETTING IN “WORK SUPPORT”

1. Select “INTELLIGENT KEY” of “BCM”.

2. Select “LO- BATT OF KEY FOB WARN” in “WORK SUPPORT” mode.

3. Check “LO- BATT OF KEY FOB WARN” in “WORK SUPPORT”.

Refer to DLK-43, "INTELLIGENT KEY : CONSULT-III Function (BCM - INTELLIGENT KEY) (With Super Lock)".

Is the inspection result normal? YES >> GO TO 3.

NO >> Set “LO- BATT OF KEY FOB WARN” in “WORK SUPPORT”.

3.CHECK KEY WARNING LAMP

Check key warning lamp.

Refer to DLK-94, "Component Function Check".

Is the inspection result normal? YES >> GO TO 4.

NO >> Repair or replace the malfunctioning parts.

4.CHECK INTELLIGENT KEY

Check Intelligent key.

Refer to DLK-91, "Component Function Check".

Is the inspection result normal? YES >> GO TO 5.

NO >> Repair or replace the malfunctioning parts.

5.CHECK INSIDE KEY ANTENNA

Check inside key antenna.

• Instrument center: Refer to DLK-55, "DTC Logic".

• Console: Refer to DLK-57, "DTC Logic".

• Luggage room: Refer to DLK-59, "DTC Logic".

Is the inspection result normal? YES >> GO TO 6.

NO >> Repair or replace the malfunctioning parts.

6.REPLACE BCM

1. Replace BCM. Refer to BCS-93, "Removal and Installation".

2. Confirm the operation after replacement.

Is the result normal? YES >> INSPECTION END

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    Take away warning does not operate
    Diagnosis Procedure 1.CHECK DTC WITH BCM AND COMBINATION METER Check that DTC is not detected with BCM and combination meter. Is the inspection result normal? YES >> GO TO 2. NO-1 >& ...

    Door lock operation warning does not operate
    Diagnosis Procedure 1.CHECK DOOR LOCK FUNCTION Check door lock function. Does door lock/unlock using door request switch? YES >> GO TO 2. NO >> Refer to DLK-85, "Component Fu ...

    Other materials:

    P012B TC boost sensor
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK GROUND CONNECTIONS 1. Turn ignition switch OFF. 2. Check ground connection E38. Refer to Ground inspection in GI-44, "Circuit Inspection". Is the inspection result normal? YES >> GO TO 2. NO >> Repair or ...

    B209f cranking request circuit
    DTC Logic DTC DETECTION LOGIC NOTE: If DTC B209F is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to PCS- 59, "DTC Logic". DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Perform DTC CONFIRMATION PROCEDURE for DTC P1650. Re ...

    Diagnosis system (ipdm e/r) (with intelligent key system)
    Diagnosis Description AUTO ACTIVE TEST Description In auto active test mode, the IPDM E/R sends a drive signal to the following systems to check their operation. • Oil pressure warning lamp (only for K9K engine models) • Rear window defogger • Front wiper motor • Parking lamp • ...