Nissan Juke Service and Repair Manual : Throttle valve closed position learning

Description

Throttle Valve Closed Position Learning is an operation to learn the fully closed position of the throttle valve by monitoring the throttle position sensor output signal. It must be performed each time harness connector of electric throttle control actuator or ECM is disconnected.

• Electric throttle control actuator is removed.

• Electric throttle control actuator is replaced.

• ECM is replaced.

NOTE

:
The necessary operation is different depending on the operation result of ECM data save or write. Always perform the operation according to procedures. Refer to EC-882, "Work Procedure".

Work Procedure

1.START

1. Make sure that accelerator pedal is fully released.

2. Turn ignition switch ON and wait at least 15 seconds.

Make sure that throttle valve moves during the above 15 seconds by confirming the operating sound.

3. Turn ignition switch OFF and wait at least 4 minutes.

4. Turn ignition switch ON.

>> END

    EGR volume control valve closed position learning
    Description EGR Volume Control Valve Closed Position Learning is an operation to learn the fully closed position of the EGR volume control valve by monitoring the EGR volume control valve control ...

    Service regeneration
    Description Service Regeneration is performed with CONSULT-III to reduce particulate matter in diesel particulate filter. Service Regeneration should be performed in the following cases. • EC ...

    Other materials:

    LAN System can system (type 6)
    DTC/CIRCUIT DIAGNOSIS Main line between IPDM-E and DLC circuit Diagnosis Procedure 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the following terminals and connectors for damage, bend and loose connection (connector s ...

    B26F8 BCM
    DTC Logic DTC DETECTION LOGIC NOTE: DTC B26F8 can be detected even though the related circuit is not used in this vehicle. DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON and wait 1 second. 2. Check DTC in “Self Diagnostic Result” mode of “ ...

    B210C starter control relay
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B210C is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to PCS-30, "DTC Logic". • When IPDM E/R power supply voltage is low (Approx. 7 - 8 V for about 1 second), the DTC B210C may be detected. ...