Nissan Juke Service and Repair Manual : EGR volume control valve closed position learning

Nissan Juke Service and Repair Manual / Engine Control System K9K / Basic inspection / EGR volume control valve closed position learning

Description

EGR Volume Control Valve Closed Position Learning is an operation to learn the fully closed position of the EGR volume control valve by monitoring the EGR volume control valve control position sensor output signal.

Work Procedure

1.START

1. Turn ignition switch ON.

2. Perform ???EGR ADAPTIVES??? in WORK SUPPORT mode with CONSULT-III.

3. Turn ignition switch OFF and wait at least 30 seconds.

4. Start engine and let it idle.

5. Select ???DATA MONITOR??? mode with CONSULT-III.

6. Check that the ???NEW EGR/V OFFSET??? and ???LAST EGR/V OFSET??? indication.

0.75V < NEW EGR/V OFFSET = LAST EGR/V OFSET < 1.5V

>> END

    Additional service when replacing ECM
    Description When replacing ECM, this procedure must be performed. Work Procedure 1.PRECONDITIONING • Connect a CONSULT-III • Connect a battery charger • Electric load switch is OFF • Wa ...

    Throttle valve closed position learning
    Description Throttle Valve Closed Position Learning is an operation to learn the fully closed position of the throttle valve by monitoring the throttle position sensor output signal. It must be pe ...

    Other materials:

    Seats
    WARNING • Do not ride in a moving vehicle when the seatback is reclined. This can be dangerous. The shoulder belt will not be against your body. In an accident, you could be thrown into it and receive neck or other serious injuries. You could also slide under the lap belt and receive seri ...

    Radiator cap : Inspection
    • Check valve seat (A) of radiator cap. B : Metal plunger - Check that valve seat is swollen to the extent that the edge of the plunger cannot be seen when watching it vertically from the top. - Check that valve seat has no soil and damage. • Pull negative-pressure valve to open it, and t ...

    A/C switch
    Component Function Check 1.CHECK A/C ON SIGNAL With CONSULT-III 1. Turn ignition switch ON. 2. Select “AIR CONDITIONER” of “BCM” using CONSULT-III. 3. Select “AIR COND SW” in “DATA MONITOR” mode, and check status under the following condition. Is the inspection result norma ...