Nissan Juke Service and Repair Manual : Diagnosis system (BCM)

Common item

COMMON ITEM : CONSULT-III Function (BCM - COMMON ITEM)

APPLICATION ITEM

CONSULT-III performs the following functions via CAN communication with BCM.

SYSTEM APPLICATION


SYSTEM APPLICATION

BCM can perform the following functions for each system.

NOTE

:
It can perform the diagnosis modes except the following for all sub system selection items.

NOTE:


NOTE

:

• *1: This item is displayed, but not used.

• *2: For models with automatic A/C, this diagnosis mode is not used.

FREEZE FRAME DATA (FFD)

The BCM records the following vehicle condition at the time a particular DTC is detected, and displays on CONSULT-III.

Door lock


Door lock

DOOR LOCK : CONSULT-III Function (BCM - DOOR LOCK) (Without Super Lock)

BCM CONSULT-III FUNCTION

CONSULT-III performs the following functions via CAN communication with BCM.

WORK SUPPORT

*: P range interlock door lock can be selected for M/T models, but automatic


*: P range interlock door lock can be selected for M/T models, but automatic door lock/unlock function does not operate.

DATA MONITOR

ACTIVE TEST


ACTIVE TEST

*: BD UNLK function does not operate.


*: BD UNLK function does not operate.

Intelligent key

INTELLIGENT KEY : CONSULT-III Function (BCM - INTELLIGENT KEY) (Without Super Lock)

WORK SUPPORT


SELF-DIAG RESULT


SELF-DIAG RESULT

Refer to BCS-67, "DTC Index".

DATA MONITOR


*1: It is displayed but does not operate on CVT models.


*1: It is displayed but does not operate on CVT models.

*2: OFF is displayed when brake pedal is depressed while brake switch power supply is OFF.

ACTIVE TEST


Trunk


Trunk

TRUNK : CONSULT-III Function (BCM - TRUNK) (Without Super Lock)

DATA MONITOR

ECU diagnosis information


    Back door opener system
    System Diagram System Description BACK DOOR OPENER OPERATION When back door opener switch is pressed, BCM operates back door opener actuator. NOTE: Back door opener actuator is not for lock ...

    ECU diagnosis information
    BCM List of ECU Reference ...

    Other materials:

    P0657 ECM relay
    DTC Logic DTC DETECTION LOGIC NOTE: When IPDM E/R DTC is indicated with DTC P0657, IPDM E/R DTC must be checked first. Diagnosis Procedure 1.CHECK GROUND CONNECTION 1. Turn ignition switch OFF. 2. Check ground connection E38. Refer to Ground Inspection in GI-44, "Circuit Inspection ...

    B2099 ignition relay off stuck
    Description • IPDM E/R operates the ignition relay when it receives an ignition switch ON signal from BCM via CAN communication. • Turn the ignition relay OFF by pressing the push-button ignition switch once when the vehicle speed is 4 km/ h (2.5 MPH) or less. • Turn the ignition relay OFF w ...

    MR16DDT : Removal and Installation
    REMOVAL 1. Disconnect the battery cable from the negative terminal. Refer to PG-124, "Removal and Installation". 2. Drain engine coolant from radiator. Refer to CO-11, "Draining". 3. Remove charge air cooler. Refer to EM-31, "Removal and Installation". 4. Remove C ...