Nissan Juke Service and Repair Manual : Key ID warning does not operate

Diagnosis Procedure

1.CHECK DTC WITH BCM AND COMBINATION METER

Check that DTC is not detected with BCM and combination meter.

Is the inspection result normal? YES >> GO TO 2.

NO-1 >> Refer to BCS-67, "DTC Index". (BCM) NO-2 >> Refer to MWI-36, "DTC Index". (Combination meter)

2.CHECK INTELLIGENT KEY

Check Intelligent Key.

Refer to DLK-91, "Component Function Check".

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace the malfunctioning parts.

3.CHECK INSIDE KEY ANTENNA

Check inside key antenna.

• Instrument center: Refer to DLK-55, "DTC Logic".

• Console: Refer to DLK-57, "DTC Logic".

• Luggage room: Refer to DLK-59, "DTC Logic".

Is the inspection result normal? YES >> GO TO 4.

NO >> Repair or replace the malfunctioning parts.

4.CHECK KEY WARNING LAMP

Check key warning lamp.

Refer to DLK-94, "Component Function Check".

Is the inspection result normal? YES >> GO TO 5.

NO >> Repair or replace the malfunctioning parts.

5.REPLACE BCM

1. Replace BCM. Refer to BCS-93, "Removal and Installation".

2. Confirm the operation after replacement.

Is the result normal? YES >> INSPECTION END

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    Door lock operation warning does not operate
    Diagnosis Procedure 1.CHECK DOOR LOCK FUNCTION Check door lock function. Does door lock/unlock using door request switch? YES >> GO TO 2. NO >> Refer to DLK-85, "Component Fu ...

    Door lock status indicator does not illuminate
    Diagnosis Procedure 1.CHECK DOOR LOCK STATUS INDICATOR Check door lock status indicator. Refer to DLK-83, "Component Function Check". Is the inspection result normal? YES >> G ...

    Other materials:

    P0713 transmission fluid temperature sensor A
    DTC Logic DTC CONFIRMATION PROCEDURE 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test. >> GO TO 2. 2.PERFORM DTC CONFIRMATION PROCEDURE 1. Start the ...

    Drive belt
    Exploded View 1. Alternator 2. Drive belt auto-tensioner 3. Crankshaft pulley 4. A/C compressor 5. Water pump 6. Drive belt A. Possible use range B. Range when new drive belt is installed C. Indicator Checking WARNING: Perform this step when engine is stopped. • Check that ...

    Door mirror defogger does not operate
    Both sides BOTH SIDES : Description Both door mirror defoggers do not operate BOTH SIDES : Diagnosis Procedure 1.CHECK REAR WINDOW DEFOGGER Check rear window defogger. Refer to DEF-31, "Component Function Check". Is the inspection result normal? YES >> GO TO 2. NO > ...