Nissan Juke Service and Repair Manual : DTC/circuit diagnosis

Basic inspection
DIAGNOSIS AND REPAIR WORK FLOW Work Flow OVERALL SEQUENCE DETAILED FLOW 1.GET INFORMATION FOR SYMPTOM 1. Get detailed information from the customer about the symptom (the condition and the en ...

B2621 inside antenna
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “INSIDE ANT DIAGNOSIS” in “WORK S ...

Other materials:

P0720 output speed sensor
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Be careful of the driving speed. 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test. > ...

Audio unit
Removal and Installation REMOVAL 1. Remove cluster lid C. Refer to IP-12, "Exploded View". 2. Remove audio unit screws. 3. Disconnect audio unit connectors to remove audio unit and brackets as a single unit. 4. Remove brackets screws to remove audio unit. INSTALLATION 1. Install ...

All-Wheel Drive (AWD) mode switch operations
AWD mode switch The All-Wheel Drive (AWD) system is used to select the 2WD (Two-Wheel Drive), AWD-V or AWD mode depending on the driving conditions. The AWD mode indicator lights ( (green), ) are located in the instrument panel. The AWD mode indicator lights (green) illuminate when the ig ...