Nissan Juke Service and Repair Manual : Anti-hijack function does not operate

Diagnosis Procedure

1.CHECK “DOOR LOCK–UNLOCK SET” SETTING IN “WORK SUPPORT”

1. Select “DOOR LOCK” of “BCM” using CONSULT-III.

2. Select “DOOR LOCK-UNLOCK SET” in “WORK SUPPORT” mode.

3. Check “DOOR LOCK-UNLOCK SET” in “WORK SUPPORT” Refer to DLK-41, "DOOR LOCK : CONSULT-III Function (BCM - DOOR LOCK) (With Super Lock)".

Is the inspection result normal? YES >> GO TO 2 NO >> Set “DOOR LOCK-UNLOCK SET” in “WORK SUPPORT”.

2.REPLACE BCM

1. Replace BCM. Refer to BCS-93, "Removal and Installation".

2. Confirm the operation after replacement.

Is the result normal? YES >> INSPECTION END

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    Super lock does not operate
    All door ALL DOOR : Diagnosis Procedure 1.CHECK SUPER LOCK ACTUATOR Check front driver side super lock actuator. Refer to DLK-99, "DRIVER SIDE : Component Function Check". Is the in ...

    Back door does not opened
    Diagnosis Procedure 1.CHECK BACK DOOR OPENER SWITCH Check back door opener switch. Refer to DLK-69, "Component Function Check". Is the inspection result normal? YES >> GO TO 2 ...

    Other materials:

    Side oil seal
    Removal and Installation REMOVAL 1. Remove front drive shafts. Refer to FAX-53, "Removal and Installation". 2. Remove differential side oil seals (1) from clutch housing and transaxle case, using an oil seal remover. CAUTION: Never damage transaxle case and clutch housing. INSTA ...

    P0120 TP sensor
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK GROUND CONNECTIONS 1. Turn ignition switch OFF and wait at least 20 seconds. 2. Check ground connection E38. Refer to Ground inspection in GI-44, "Circuit Inspection". Is the inspection result normal? YES >> GO TO ...

    Push-button ignition switch operation
    When the ignition switch is pushed without depressing the brake pedal (Continuously Variable Transmission models) or the clutch pedal (manual transmission models), the ignition switch position will change as follows: • Push once to change to ACC. • Push two times to change to ON. • Push thre ...