Nissan Juke Service and Repair Manual : Unlock link function does not operate

Diagnosis Procedure

1.CHECK DRIVER SIDE OR PASSENGER SIDE DOOR SWITCH

Check driver side or passenger side door switch.

Refer to DLK-258, "Component Function Check".

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair or replace the malfunctioning parts.

2.REPLACE BCM

1. Replace BCM. Refer to BCS-93, "Removal and Installation".

2. Confirm the operation after replacement.

Is the result normal? YES >> INSPECTION END

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    Key ID warning does not operate
    Diagnosis Procedure 1.CHECK DTC WITH BCM AND COMBINATION METER Check that DTC is not detected with BCM and combination meter. Is the inspection result normal? YES >> GO TO 2. NO-1 >& ...

    Squeak and rattle trouble diagnoses
    Work Flow CUSTOMER INTERVIEW Interview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet during the interview to document the ...

    Other materials:

    P1225 TP sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. TESTING CONDITION: Before performing the following proced ...

    Fuel level sensor signal circuit
    Component Function Check 2WD MODELS 1.CHECK COMBINATION METER OUTPUT SIGNAL Select the “Data Monitor” for the “METER/M&A” and compare the “FUEL METER” monitor value with the fuel gauge reading on the combination meter. Does monitor value match fuel gauge reading? YES >&g ...

    Blower fan on signal
    Component Function Check 1.CHECK BLOWER FAN ON SIGNAL With CONSULT-III 1. Turn ignition switch ON. 2. Select “AIR CONDITIONER” of “BCM” using CONSULT-III. 3. Select “FAN ON SIG” in “DATA MONITOR” mode, and check status under the following condition. Is the inspection result ...