Nissan Juke Service and Repair Manual : Key ID warning does not operate

Diagnosis Procedure

1.CHECK DTC WITH BCM AND COMBINATION METER

Check that DTC is not detected with BCM and combination meter.

Is the inspection result normal? YES >> GO TO 2.

NO-1 >> Refer to BCS-67, "DTC Index". (BCM) NO-2 >> Refer to MWI-36, "DTC Index". (Combination meter)

2.CHECK INTELLIGENT KEY

Check Intelligent Key.

Refer to DLK-262, "Component Function Check".

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace the malfunctioning parts.

3.CHECK INSIDE KEY ANTENNA

Check inside key antenna.

• Instrument center: Refer to DLK-230, "DTC Logic".

• Console: Refer to DLK-232, "DTC Logic".

• Luggage room: Refer to DLK-234, "DTC Logic".

Is the inspection result normal? YES >> GO TO 4.

NO >> Repair or replace the malfunctioning parts.

4.CHECK KEY WARNING LAMP

Check key warning lamp.

Refer to DLK-265, "Component Function Check".

Is the inspection result normal? YES >> GO TO 5.

NO >> Repair or replace the malfunctioning parts.

5.REPLACE BCM

1. Replace BCM. Refer to BCS-93, "Removal and Installation".

2. Confirm the operation after replacement.

Is the result normal? YES >> INSPECTION END

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    Door lock operation warning does not operate
    Diagnosis Procedure 1.CHECK DOOR LOCK FUNCTION Check door lock function. Does door lock/unlock using door request switch? YES >> GO TO 2. NO >> Refer to DLK-256, "Component F ...

    Unlock link function does not operate
    Diagnosis Procedure 1.CHECK DRIVER SIDE OR PASSENGER SIDE DOOR SWITCH Check driver side or passenger side door switch. Refer to DLK-258, "Component Function Check". Is the inspection ...

    Other materials:

    P0717 input speed sensor A
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test. After the repai ...

    Removal and Installation Procedure for CVT Unit Connector
    REMOVAL • Rotate bayonet ring (A) counterclockwise. Pull out CVT unit harness connector (B) upward and remove it. INSTALLATION 1. Align marking (A) on CVT unit harness connector terminal with marking (B) on bayonet ring. Insert CVT unit harness connector. 2. Rotate bayonet ring clockwise. ...

    System temporarily unavailable
    Condition A In specific scenarios where the radar sensor encounters electromagnetic interference from an external radar source, the system may find it impossible to accurately track the vehicle ahead. To ensure reliability, the Intelligent Forward Collision Warning (I-FCW) ...